Roland ColorCamm PC-12 User Manual page 15

PE lever
This lever is for detecting
whether media is present.
Media-feed roller (metal)
This roller feeds supplied media.
"Open" sensor
This detects whether the front cover is open
or closed.
Printing heads
These are mounted on the carriage
and carry out printing. The printing
heads should never be touched
except when cleaning them.
RE sensor (black)
This detects whether the ink-
ribbon cartridge has ended.
Bobbin shaft
This winds the ink-ribbon
cartridge.
Release lever (blue)
Use this when media is jammed. Press the
lever down and pull out the media. When
you close the front cover, the lever returns
to its original position.
Media-ejection roller
This is the roller that ejects media.
Cleaning pads
(orange and white)
These are pads for cleaning the printing
heads. Do not try to remove them.
If they become damaged, refer to "Part 6
Maintenance" and replace them with new
ones.
Platen
This is a rubber plate that printing heads press down during
printing. If it becomes soiled, refer to "Part 6 Maintenance"
to clean it.
Carriage
This automatically picks up the required ink-
ribbon cartridge from the ink-ribbon cartridge
holders.
Media auto-cutter
This severs the media from the roll.
HP sensors (black; two locations)
These detect the type of ink-ribbon cartridge and the
reference position of the carriage.
Blade holder
This performs cutting.
Tool carriage
This is where the blade holder is installed.
Crop-mark sensor
This detects the reference position for cutting after
printing crop marks.
Part 1 Getting Started
13