Panasonic WJ-ND200K Setup Instructions page 59

Settings for SNMP network [SNMP Setup]
Perform the settings for the SNMP. Perform the settings for the status check of the unit, etc. by connecting the
SNMP manager.
Screenshot 1
Click the [Comm] button in the "Setup" panel and then
click the "SNMP Setup" tab. The "SNMP Setup" page
will be displayed.
Step 1
Perform the following setup items.
I COMMUNITY
Enter a name used for SNMP authentication in alphanu-
meric characters. Enter up to 32 characters using
alphanumeric characters and the following marks.
I CONTACT
Enter the mail address of an administrator of this unit.
Enter up to 255 characters using alphanumeric charac-
ters and the following marks.
I SYSTEM NAME
Enter a system name in alphanumeric characters to
manage this unit by the SNMP system, for example,
No1. Enter up to 255 characters using alphanumeric
characters and the following marks.
I LOCATION
Enter a location name (location where this unit is
installed) in alphanumeric characters, for example, 2F.
Enter up to 255 characters using alphanumeric charac-
ters and the following marks.
Step 2
Click the [SET] button after completing the settings.
Note:
The following alphanumeric characters and marks
can be entered.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1
2 3 4 5 6 7 8 9 ! " # $ % ' ( ) * + , - . /: ; < = > ? @ [ \ ]
^ _ ` { | } ~
59