Panasonic WJ-ND200K Setup Instructions page 41

Note:
When "MANUAL" is selected for "DURATION"
(recording duration), recording will be performed for
at least 8 seconds at an event occurrence as long as
the alarm is not canceled.
Important:
• Perform the camera settings as follows for pre-event
recording in MPEG-4.
• Refresh interval: 1 sec. or more
• Bit rate per client: 4 096 kbps or less
Failure to observe the above may cause the record-
ing duration of the recorded data to be different from
the set recording duration for the pre-event record-
ing.
• Depending on the network traffic or environment,
images will not be recorded as configured (by setting
the pre-event recording rate and the recording dura-
tion).
[AUDIO REC]
Select ON or OFF to determine whether or not to record
audio together with images for each channel.
OFF: Audio will not be recorded.
ON: Audio will be recorded.
Default: OFF
Note:
• Audio will be recorded together with images.
It is impossible to record only audio.
• Only CH1 is available for audio recording for the WJ-
NT304/WJ-NT314.
CH2 - 4 are always unavailable for audio recording.
• It is impossible to record audio while performing the
SD memory recording.
When a recording rate except for OFF is selected for
"SD MEMORY REC", audio recording for the
respective camera channel will automatically be set
to OFF.
Important:
• When selecting ON for audio recording, make sure
that the audio capturing function of the respective
camera is enabled.
In this case, select "32kbps" for the audio bit rate
setting of the camera.
• To record audio, select "Mic input" or "Interactive
(Full-duplex)" for "Audio mode" on the setup menu of
the camera.
(Depending on the model or the version of the cam-
era, "Interactive (Full-duplex)" is not available.)
• Audio will be recorded regardless of the display pat-
tern (single screen or 4-screen).
I CAMERA SETUP
Set the recording rate for the SD memory recording for
each channel.
The following recording rates are available for "SD
MEMORY REC".
OFF/0.1 ips/0.5 ips/1 ips
When "OFF" is selected, the SD memory recording will
not be performed for the respective channel.
Notes:
• The recording rate setting for "SD MEMORY REC" is
available only for cameras with the SD memory
recording function and their image compression
method is set to "M-JPEG".
• The recording rate for "SD MEMORY REC" should
be less than the recording rate set for "LIVE VIDEO".
When the camera in use is WJ-NT304/WJ-NT314,
recording will be performed at 0.2 ips even when
"0.5 ips" or "1 ips" is selected for the recording rate
for "SD MEMORY REC".
• When setting the recording rate for "SD MEMORY
REC", make sure that "Use" is selected for the "SD
memory card" setting of the camera.
When "Use" is not selected or when no SD memory
card is mounted on the camera, error messages
may be displayed several times a day, and recording
may be interrupted for around 20 seconds each time
the error message is displayed.
This may also occur when the firmware of the cam-
era is older. In this case, upgrade the firmware of the
camera.
When the firmware version of the camera in use is
not the version listed below, upgrade the firmware.
41