Date/Time Settings - JVC GR-DVP3 Instructions Manual

SET/SELECT Button
Power lamp
Power Switch
Lock Button
Display
W I PE / FADER OF F
PROGR AM AE
W. BAL AN E C
CAMER A
MANUA L
SYSTE M
D I SPL AY
DSC
END
ON SC RE N E – LCD / TV
DATE / T I ME – A U T O
T I ME CODE – O F F
CLOCK D E C 25 '01
ADJ . : 5 30 PM
RETUR N
CLOCK D E C 25 '01
ADJ . : 5 30 PM
MENU Button
+, – Button
DISPLAY Menu

Date/Time Settings

The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
( pg. 44, 45).
1
Set the Power Switch to "
the Lock Button located on the switch, then open
the LCD monitor fully or pull out the viewfinder
fully. The power lamp lights and the camcorder is
turned on.
2
Press MENU. The Menu Screen appears.
3
Press + or – to select "
SELECT. The DISPLAY Menu appears.
4
Press + or – to select "CLOCK ADJ.", and press SET/
SELECT. "Month" is highlighted.
Press + or – to input the month, and press SET/
SELECT. Repeat to input the day, year, hour and
minute. Press + or – to select " RETURN", and
press SET/SELECT twice. The Menu Screen closes.
Built-in Clock's Rechargeable Lithium Battery
To store the date/time in memory, the clock's rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock's
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock's lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock's rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:
Even if you select "CLOCK ADJ.", if the parameter is not
highlighted the camcorder's internal clock continues to
operate. Once you move the highlight bar to the first
date/time parameter (month), the clock stops. When you
finish setting the minute and press SET/SELECT, the date
and time begin operation from the date and time you
have just set.
13
EN
" while pressing down
DISPLAY", and press SET/