JVC GR-DVP3 Instructions Manual page 7

How To Attach The Grip Belt
1 Remove the pad and separate the two straps.
2 Thread one end of the strap
eyelet, then pass the other end through the loop.
3 Repeat the same procedure to attach the strap
to the other eyelet.
4 Connect the strap
through the buckle, then adjust the grip
( pg. 12).
5 Attach the pad.
2
through the
and and thread the strap
1
3
4
5
How To Attach The Strap
1 Thread one end of the strap through the eyelet,
then pass the other end through the loop.
2 Attach the screw to the tripod mounting socket.
To tighten the screw firmly, use a coin, etc.
3 Adjust the length with the adjuster.
NOTES:
You can use the strap as a shoulder strap by
adjusting the length with the adjuster.
Because the screw may cause damage to the
camcorder, make sure to attach the screw to the
tripod mounting socket when carrying the
camcorder.
Use the strap only with this camcorder.
Do not grip the camcorder too firmly when the
screw is attached. Doing so may cause damage to
the tripod mounting socket.
1
7
EN
2
3