Index - JVC GR-DVP3 Instructions Manual

92
EN
Indications
INSERT ERROR!
<CANNOT EDIT
ON A LP RECORDED
TAPE>
<CHECK TAPE'S ERASE
PROTECTION TAB>
COPYING FAILED
MEMORY CARD!
PLEASE
FORMAT
NO FILES STORED
NO SOUND FILES
Unsupported file!
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
CARD ERROR!
CHECK CARD'S WRITE
PROTECTION SWITCH
Appears if Insert Editing is attempted on a tape recorded in the LP
mode.
Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
Appears in the following cases when dubbing from a tape to a memory
card (as digital stills or video clips):
– when no memory card is loaded.
– when the memory card's memory is full.
– when the memory card is not formatted.
– when a copy-protected SD Memory Card is loaded.
Appears if a memory card is not loaded when SNAPSHOT is pressed
while the Power Switch is set to "
Switch is set to "MEMORY".
Appears when there is a problem with a memory card and its memory is
corrupt, or it has not been initialized. Initialize the memory card.
Appears when the Power Switch is set to "
Switch is set to "MEMORY" if there are no image files stored in the memory
card.
Appears if there are no video clip files stored in the memory card when
the video clip mode is engaged by pressing the SET/SELECT button.
Appears after a memory card is initialized.
Appears if there are no sound files stored in the memory card when the
sound effect mode is engaged by pressing the SET/SELECT button or
D.SOUND is pressed during video recording.
Appears when a file in a format other than MP3 for digital sound or DCF
for image is selected.
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using
the camcorder. If the indication remains, consult your nearest JVC dealer.
Appears when the camcorder takes more than 60 seconds to recognize
the loaded memory card. Remove the memory card once and insert it
again. Repeat these procedures until no indication appears. If the
indication still appears, the memory card is corrupted.
Appears when you attempt to shoot digital still images while a copy-
protected SD Memory Card is loaded.

INDEX

Function
" or " " and the VIDEO/MEMORY
" and the VIDEO/MEMORY
Indications (cont.)
( pg. 68)
( pg. 68)
( pg. 60, 61)
( pg. 28)
( pg. 38)