Details - JVC GR-DVP3 Instructions Manual

DETAILS

I T E M S
➪
Power
( pg. 10)
➪
VIDEO
RECORDING
( pg. 20, 21)
❍ Perform charging where the temperature is between 10°C and
35°C (50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal
temperature range for charging. If the environment is too cold,
charging may be incomplete.
❍ Charging times noted above are for a fully discharged battery pack.
❍ Charging time varies according to the ambient temperature and
the status of the battery pack.
❍ To avoid interference with reception, do not use the AC Power
Adapter/Charger near a radio.
❍ Since the AC Power Adapter/Charger processes electricity
internally, it becomes warm during use. Be sure to use it only in
well-ventilated areas.
❍ When you use the LCD monitor outdoors in direct sunlight, the
LCD monitor may be difficult to see. If this happens, use the
viewfinder instead.
❍ The cassette holder cannot be opened unless a power supply is
attached.
❍ There may be a delay after you open the cassette holder cover
until the cassette holder opens. Do not use force.
❍ Once the cassette holder is closed, it recedes automatically. Wait
until it recedes completely before closing the cassette holder
cover.
❍ When the Recording Start/Stop button is pressed, it may take a
few seconds before actual recording starts. " " starts rotating
when the camcorder actually starts recording.
❍ The time required to calculate and display the remaining tape
length, and the accuracy of the calculation, may vary according
to the type of tape used.
❍ "TAPE END" appears when the tape reaches its end, and the
power goes off automatically if left in this condition for
5 minutes. "TAPE END" also appears when a cassette at its end is
loaded.
❍ During recording, sound is not heard from the speaker. To hear
the sound, connect optional headphones to the PHONE
connector on the Docking Station. The sound volume is at the
level it was adjusted to during playback (
❍ During Interface Shooting, the "Tape Running" indicator and
warning indications (
shown; they appear reversed in the display as they would when
viewing a mirror, but are not reversed in the recording.
❍ The tape remaining indicator does not appear during interface
shooting. However, when the remaining time reaches 2 minutes,
the indicator appears showing the remaining time:
(blinking)
N O T E S
pg. 91, 92) are the only ones that are
(blinking) (blinking)
77
EN
pg. 23).