Travis Industries 21 TRV GreenSmart Installation Manual page 61

Optional Equipment
21 Pull the "RECEIVER" connector through the control panel and attach to the receiver (see Figure
27). Place batteries into the receiver and transmitter (see Figure 28).
19 At this time the remote receiver is powered up. Make sure the continuous/intermittent pilot switch
is set to "GreenSmart Pilot" (otherwise, the pilot will spark - see Figure 29). Calibrate the receiver
to the transmitter (see Figure 30 - use a paperclip to press the "PRG" button, let it beep, then
press any button on the transmitter – the receiver should beep 5 times – see the operating
instructions for further details). We recommend you test the electric functions of the fireplace at
this time with the control panel removed.
© Travis Industries
(for qualified installers only)
Figure 27
Figure 29
4101014
61
Figure 28
Figure 30
100-01208_002