Finalizing The Installation; Accent Light Bulb Installation; Battery Installation - Travis Industries 21 TRV GreenSmart Installation Manual

Finalizing the Installation

Steps for Finalizing the Installation
1. Remove the glass (see page 41).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulb is in place.
NOTE: .Take care to not touch the bulb with your fingers (use a cloth or paper towel).
4. Install the four AA batteries (included in the owner's pack) into the battery holder (make sure they contact the
terminals - see the illustration below). The AA batteries act as a power backup in case the household (AC) power
goes out (they also power the comfort control). Install the 9v battery (included in the owner's pack) into control
panel light assembly (see the illustration below). The battery holder is held in place with Velcro and may be
removed for easier access.
© Travis Industries
Battery Holder for
Control Panel Lights
Swing the access
door down to
access the area
below the firebox.
Swing the
concealment cover
down to expose
the controls.
4101014
(for qualified installers only)
AA Battery Tray
39
AA
Battery
Holder
100-01208_002