This chapter provides information concerning the following:
For information about...
Using LANVIEW
Troubleshooting Checklist
Using the Reset Switch
This device contains a battery that is not considered a user replaceable part. If the battery
needs to be replaced, contact customer service for repair.
Using LANVIEW
The switch uses the Enterasys Networks built‐in visual diagnostic and status monitoring
system called LANVIEW. For the location of LANVIEW LEDs on the C3G124‐24P and
C3G124‐48P, refer to Figure 4‐1 and Figure
quickly observe network status for diagnosing switch and network problems.
Caution: There is a risk of explosion if the battery is replaced with an incorrect type. A
used battery may be safely disposed in a municipal waste stream.
Precaucion: Hay riesgo de explosion si la bateria se reemplaza con el typo incorrecto.
Puede tirar la bateria usada en la basura
Troubleshooting
4‐2, respectively. These LEDs allow you to
SecureStack C3 Installation Guide 4-1
4
Refer to page...
4-1
4-7
4-8