Connecting To An Ibm Or Compatible Device; Db9 Male Console Port Pinout Assignments - Enterasys SecureStack C3G124-24P Installation Manual

Figure 3-9
Â
Á
À

Connecting to an IBM or Compatible Device

To connect an IBM PC or compatible device, running the VT terminal emulation, to a
switch Console port (Figure
1. Connect the DB9 female connector at one end of the cable (not supplied) to the
Console port on the switch. (If there is a switch designated as the Manager, connect to
its Console port.)
2. Plug the DB9 female connector at the other end of cable into the communications port
on the PC.
3. Turn on the PC and configure your VT emulation package with the following
parameters:
Parameter
Mode
Transmit
Bits Parity
Stop Bit
When these parameters are set, the Startup screen will display. Proceed to "Connecting to
the Network" on page 3‐22.

DB9 Male Console Port Pinout Assignments

1 Pin 2, Received Data (input)
2 Pin 3, Transmitted Data (output)
3 Pin 5, Signal Ground
All other pins not connected.
3‐10), proceed as follows:
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
SecureStack C3 Installation Guide 3-19