Fcc Compliance - Webster IRP 4100 Installation Manual

FCC COMPLIANCE

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
The Webster is supplied with a grounded AC power cable, a shielded
serial communications cable, and a double-shielded VGA video
cable of a type and quality to ensure compliance with the FCC rules.
Use only these original or equivalent cables for continued FCC
compliance.
WARNING!
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
The Webster IRP system has been tested and found to comply with
the limits for a Class A digital device pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial installation. However,
there is no guarantee that interference will not occur in a particular
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
this Installation and Operation manual, may cause harmful
interference to radio communications. If this equipment does cause
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the Webster and the receiver.
• Plug the Webster into a different outlet so that the Webster and
the receiver are on different branch circuits.
FCC COMPLIANCE 47