Table of Contents
Advertisement
Troubleshooting
Use this section if you have operation problems with Webster 4100,
4500, or 5100 hardware. If you have installation problems, see the
respective sections on hardware and software installation. Refer to
the Webster User Guide for information about software alignment
and troubleshooting.
Webster IRP is manufactured to comply with a variety of electrical,
physical, radio interference, and laser operation safety
requirements. Do not continue to use malfunctioning equipment or
attempt to correct hardware problems without observing all related
safety precautions as directed.
Hardware Condition Indicators
The green power indicator light is located at the lower left-hand
corner of the Webster screen. It is on when the Main Power switch is
on, power cables are properly connected, the power entry fuse is
intact, and the Webster power supply is functioning properly.
OPERATING LEDS
The operating lights are located just beneath the Webster screen
header cover, and are visible above the midpoint of the screen.
•
When your electronic pen is positioned near or on the screen,
the red operating light turns on.
•
When there is a Webster initialization error (refer to the Webster
User Guide), the red operating light blinks (and the indicator
speaker in the header also beeps repeatedly).
•
When the electronic pen tip switch is depressed, the green
operating light turns on.
•
When either of the electronic pen barrel buttons is depressed
without the pen tip switch being depressed, the green operating
light blinks.
42
TROUBLESHOOTING
Advertisement
Table of Contents
Troubleshooting
