Removing And Replacing The Irp 4500 Screen; Removing The Webster Screen - Webster IRP 4100 Installation Manual

If clearance is not adequate, prepare the projector for a move:
1 Turn off the power and unplug the power cable at the front of the
projector. Lift the projector off the IRP 4500 projector mounting
plate, noting the original placement of the feet. Be careful while
handling the projector not to disturb the mechanical settings of
the projector height, tilt, focus, or zoom.
2 Handle the projector separately for the move. Do not try to carry
it on the projector mounting platform.
After the move:
1 Replace the projector on the projector mounting platform in the
same location as prior to removing it.
2 Plug in the projector power cable at the front of the projector.
As long as proper you exercise proper care, you do not need to be
concerned about hardware alignments being affected by a move.

Removing and Replacing the IRP 4500 Screen

Follow these instructions to remove the Webster screen from the IRP
4500.
Locate and have ready to use:
• Small or medium sized phillips screwdriver
• Thin-bladed screwdriver or small knife
• 5/32" allen wrench (located in your IRP 4500 toolkit inside the
accessory compartment on the left front of the console)

REMOVING THE WEBSTER SCREEN

To remove the Webster screen:
1 Turn off main power to the IRP 4500 and unplug the main power
cord.
2 To remove the Webster screen header cover:
a remove the two thumb screws at the ends of the top of the
cover.
32 MOVING THE IRP 4500