Moving The Irp 4500; Repositioning The Irp 4500 - Webster IRP 4100 Installation Manual

Moving the IRP 4500

This section provides instructions for moving and repositioning the
IRP 4500.
Remember that the IRP 4500 contains both electronic and optical
components and needs to be handled with care. Your consideration
during operation, and especially during moving, will assure that it
continues to operate reliably.
WARNING!
Safety standards relating to possible overbalance situations have
dictated that the IRP 4500 not have locking casters. This permits the
unit to roll freely when an unexpected force is applied to the board,
rather than tip over. Consequently, the unit must not be left on a
sloping floor where it could roll by itself. Also, should you block or
obstruct any of the casters, you could upset the unit if a large force
were to be applied to the board.
NOTE
NO TE :
When moving or repositioning the IRP 4500, take care to avoid
applying force to or bumping the Webster screen, screen assembly,
or screen header cover.

Repositioning the IRP 4500

To reposition the IRP 4500 at its current location:
1 Make sure that anyone assigned with moving the unit
understands the need for careful handling.
2 Remove the projector from the projector mounting platform.
3 Use the hand grip on each side of the Webster screen to push or
pull the unit when moving or repositioning.
30 MOVING THE IRP 4500