Moving The Irp 4500 To Another Room; Preparing The Projector Mounting Platform For A Move - Webster IRP 4100 Installation Manual

Moving the IRP 4500 to Another Room

You can roll the IRP 4500 anywhere that it can conveniently fit. In
selecting a place to locate the console, be sure to allow space for
accessing the required computer equipment during operation and
assure access to power and a phone line or network connection if
necessary.
Moving the IRP 4500 is best done by two people unless it just needs
to be repositioned.
WARNING!
Check door heights and other clearances before making a move. It is
especially important that the IRP 4500 not be accidentally subjected
to shocks such as might occur by impacting a door header or by
bouncing across a rugged surface.
You may find that you cannot move your IRP 4500 to another location
because the unit is too tall to fit through a door opening or other
passage. If this is the case, refer to "Removing and Replacing the IRP
4500 Screen" on page 32 or in the separate document located inside
the accessory compartment (left-rear) of the console.
To move the unit:
1 Disconnect all power and communication cables before moving
the unit.
2 Make sure that the cables are completely disconnected and/or
are safely stowed so they are not damaged or create a hazard
during movement.
3 Remove the projector from the projector mounting platform.
4 Position the keyboard tray to the side of the console and
remove, if necessary, the equipment from the tray for safety
while moving.

Preparing the Projector Mounting Platform for a Move

If you are moving the IRP 4500 only a short way and all passageways
have plenty of clearance, you may be able to leave the projector
mounting platform in its extended position for the move.
MOVING THE IRP 4500 31