Table of Contents
Advertisement
b
Remove decals from backing so this single pattern can be
broken apart into the four decals, shown below.
c
Position decals in each corner of the screen, as indicated by
the letters on the decal. These decals are backed with a low-
strength adhesive, so that they can easily be repositioned if
needed)
5
Center the image horizontally by adjusting the secondary mirror
as follows:
a
To open the center panel on the console, press inward on
the top of the panel and release it to open the latch.
b
Locate the horizontal centering knob through the rightmost
of the two cut out windows in the sheet metal plate behind
the center panel. The knob label is shown below.
c
Adjust the horizontal centering knob until the left and right
edges at the bottom of the projected image are in balanced,
using the decal grids on the screen as a guide.
24
INSTALLING THE IRP 4500
Advertisement
Table of Contents
Troubleshooting
