Table of Contents
Advertisement
If cannot move your IRP 4500 to the place of installation because the
unit is too tall to fit through a door opening or other passage, refer to
"Removing and Replacing the IRP 4500 Screen" on page 32 or in the
separate document located inside the left front compartment of the
console.
Installation
Installing the IRP 4500 involves mounting the projector, mounting
optional equipment, and making cable connections.
MOUNTING THE PROJECTOR
To mount your projector:
1
Remove your projector and projector accessories from their
packaging.
2
Connect the PROJECTOR POWER cable in the IRP 4500 cable tray to
the IEC power connector on the projector.
3
Mount the projector on the adjustable projector plate in the rear
of the console. Projector plates vary according to the projector you
use. Samples are shown below.
4
Power on the projector.
INSTALLING THE OPTIONAL KEYBOARD/MOUSE TRAY
If you purchased the keyboard/mouse tray option, it comes packaged
in a separate carton.
INSTALLING THE IRP 4500
11
Advertisement
Table of Contents
Troubleshooting
