Table of Contents
Advertisement
CHECK SEATING ON UPPER AND LOWER SPINDLES
Make sure your Webster screen is hanging properly on the two upper
mounting spindles. Both spindles should be identically saddled in
the top of their keyhole slots at the top of the back of the Webster.
Make sure your Webster screen is located properly on the two lower
mounting spindles and that the lower mounting screws are properly
tightened.
Transporting the IRP 4500
Follow these instructions if you need to move the IRP 4500 in a
vehicle to another location.
PACKAGING AND PROTECTIVE COVERING FOR THE CONSOLE
The ideal packaging and protection for the IRP 4500 is to reuse the
materials with which the unit was originally shipped. Note that those
materials were designed to constrain the console unit on the pallet
only with tie downs underneath the frame and with the two special
shipping restraining bars on either end.
Without a pallet and special packaging, the unit can also be shipped
using techniques and equipment designed for large electronic
systems. If covered and strapped to the side of a van carefully, it can
be moved as if it were a heavy piece of quality furniture. The Webster
screen is especially susceptible to scratches or cracking and should
be guarded accordingly.
If you need to remove the Webster screen to move the unit through
doorways or other passages, consider remounting it on the console
for actual transportation. This is probably the best way to protect
both pieces from mishandling and damage. Alternatively, you will
need to provide an air-tight/moisture-proof covering for the
unoccupied opening on the console and possibly a carton or other
protective covering for the separate Webster screen.
To transport the IRP 4500:
1
Please read and follow all instructions in the section
"Repositioning the IRP 4500" on page 30. All of those
instructions also apply equally to transporting the IRP 4500.
MOVING THE IRP 4500
37
Advertisement
Table of Contents
Troubleshooting
