Testing Connections; Powering On The System; What You Should See - Webster IRP 4100 Installation Manual

Testing Connections

You are now ready to power up and test your IRP 4500 for the first
time.

POWERING ON THE SYSTEM

To power on the system:
1 Plug the main power cord into the IRP 4500 control panel at one
end and into a grounded outlet on the other end.
NOTE
NO TE :
If you need an extension for the power, always use a grounded cord.
(Refer to"Preparing to Install Cables" on page 15.)
2 Turn on your host computer if it is not in the IRP 4500 console
and it is on a separate power switch.
3 Turn on the IRP 4500 Main Power and Projector Power switches
on the power panel. Also turn on the Speaker Power switch if you
want to use the console speakers.
4 Allow the projector to warm up (about one minute) and wait for
your computer to boot up. If your computer does not
automatically start up the operating system (Windows or
Macintosh), start the operating system from the keyboard.

WHAT YOU SHOULD SEE

You should see both the power light (at the lower, left-hand corner of
the screen) and the operating light (beneath the header cover, above
the top midpoint of the screen) come on. You should also see the
projector and computer come on and, after a minute or so of warm
up, light up the screen with the initial display.
If your projected image is not properly positioned on the screen or is
of the wrong size or shape for the screen, do not worry about that for
now. Those issues will be addressed "Image Adjustments" on
page 23. The important thing at this point is to get a good video
image on the screen from your computer.
INSTALLING THE IRP 4500 21