Table of Contents
Advertisement
INDICATOR SOUND SIGNALS
The indicator sound speaker is located internally near the middle of
the Webster screen header.
When there is a Webster initialization error the speaker beeps
repeatedly and the red operating light also blinks. Refer to the
Webster User Guide.
Troubleshooting the Cable Connections
If you are not getting any projected image:
•
Make sure the Projector Power and the Main Power switches on
the main control panel are both on.
•
Make sure the projector power switch is on.
•
Make sure the projector power cable is properly connected at
both ends.
•
IRP 4500 only: A minor power surge may cause the lamp to shut
off. Turn the projector off, wait at least 30 seconds, then turn it
back on to reset the projector.
•
IRP 4500 only: Make sure the fan in the built-in projector is on (it
has power).
•
Make sure there is not a lens cap on the lens.
•
Make sure the projector lamp is not off because the projector is
in standby.
•
Wait for up to one minute for the projector lamp to warm up.
•
Check the projector built-in menu display by pressing menu on
the projector control panel (or remote controller).
•
If you continue to see no evidence of projector light, your
projector lamp may be burned out and needs to be replaced.
If you are getting a projected image but not video from the computer:
•
Make sure that your computer display controller is set for a
resolution and refresh rate that is compatible with your
projector.
TROUBLESHOOTING
43
Advertisement
Table of Contents
Troubleshooting
