Host Computer Connections In The Console (Optional) - Webster IRP 4100 Installation Manual

HOST COMPUTER CONNECTIONS IN THE CONSOLE (OPTIONAL)

Ordinarily, you will be powering the computer on and off along with
the entire system using the IRP 4500 MAIN POWER switch located on
the power panel, on the left side of the console.
To route cables in the IRP 4500 console:
1 If you choose to put your host computer in the PC compartment
of the IRP 4500 console, assure that the computer will fit
comfortably in the space to allow adequate access for reaching
switches, seeing lights, and connecting cables. It will be most
convenient if your cable connectors are at the rear of the
compartment for access through the access panel in the rear.
2 Connect the COMPUTER POWER supply cord pre-wired in that
area to your computer.
3 Connect the VGA cable supplied with the IRP 4500 between your
computer and your projector (refer to your projector manual for
information about connections).
4 If you want to use your computer display monitor for an auxiliary
display, connect your original VGA cable between your monitor
and the projector.
5 Place your computer keyboard and mouse on the IRP 4500
keyboard tray (refer to "Installing the Optional Keyboard/Mouse
Tray" on page 11) and connect the cables to your host computer.
Depending on the location of these components, it may be
necessary for you to obtain extension cables for your keyboard
and/or mouse.
6 You can put other accessory equipment of your own choosing in
the accessory compartment of the IRP 4500 console if it does
not get too crowded. You can connect the AC power supply cord
pre-wired in that area to your accessory equipment.
18 INSTALLING THE IRP 4500