Callback Acknowledgment - Phonetics Sensaphone 800 User Manual

Sensaphone Model 800 User's Manual
®
Acknowledgement code." Now, or at any time during this call,
you may acknowledge the alarm with the code "555" if you are
using a Touch-Tone
• To enter "555," press the number (5) key on the Touch-Tone
phone keypad three times. The Model 800 will respond:
"Alarm Acknowledged." The Model 800 will hang up and the
dial-out sequence, including any further response to the alarm,
will be cancelled.
• If you enter the wrong code or do not enter it within 10
seconds following the conclusion of the message, the Model
800 will respond: "Error, Enter Acknowledgement code."
If you do not enter the acknowledgement a second time the
unit will say "error" then "goodbye" and hang up. The alarm
is still not acknowledged until you call back. You have a
period equal to the programmed Intercall Time to call the
unit back and enter the "555" acknowledgment code. If you
are calling from a pulse or rotary telephone, refer to Callback
Acknowledgment, Section 6.1.3, below.

6.1.3 Callback Acknowledgment

Callback Acknowledgement is a feature that allows you to
acknowledge an alarm without entering Touch-Tones
feature is disabled by default and must be enabled by entering
the key sequence below. When Callback Acknowledgment is
enabled, simply call the unit back and allow the line to ring 10
times. The unit will then answer the call, announce the alarm,
then say "Alarm Acknowledged." This indicates that the alarm
has been acknowledged.
To enable or disable Callback Acknowledgement:
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press STATUS.
STATUS
The Model 800 will say "Callback Acknowledgement Enabled"
to indicate that Callback Acknowledgment is Enabled, or
"Callback Acknowledgement Disabled" to indicate that Callback
Acknowledgement is Disabled. This method of remote alarm
87
telephone.
™
™
. This
™