Programming Zone Configuration - Phonetics Sensaphone 800 User Manual

Sensaphone Model 800 User's Manual
®
For example, if a magnetic reed switch (a normally-
closed sensor used to detect unauthorized entry) has
been wired to the Model 800, make sure that the door
or window to be monitored is shut before configuring
the zone. If a motion-detector is wired to the unit, it
is advisable to block all sources of motion from the
sensor before and during configuration.

5.1.1 Programming Zone Configuration

1. Press STANDBY to place the Model 800 in Standby
mode.
STANDBY
2. Wire sensors to the zones to the back of the Model 800 (see
Chapter 2, Section 2.10).
3. Press RUN. The red light glows when the Model 800 returns
to Run mode.
STANDBY
4. Press SET.
SET
5. Press CONFIG.
CONFIG
6. The Model 800 audibly recites the configuration for each of
the eight zones:
• If the zone is open, the Model 800 recites the number of the
zone and says "normally open."
• If the zone is closed, the Model 800 recites the number of
the zone, and says "normally closed."
• If the zone is configured as temperature, the Model 800
recites the number of the zone, followed by "Temperature."
69
RUN
RUN