Special Dialing To A Beeper Or - Phonetics Sensaphone 800 User Manual

6. Enter any remaining digits of the telephone number.
7. Press ENTER. The Model 800 will say "Enter."
ENTER
PM
4.5.4 Special Dialing to a Beeper or Pager
Your Sensaphone can be programmed to send an alarm message
to a numeric beeper/pager. The message will include the
Sensaphone's telephone number (ID number) and the Zone
numbers that are in alarm. For example, if zones 1 and 4 are
in alarm, the message on your pager would be: 8882227777-1-
4, where 8882227777 is the unit's ID number. A Sound alarm
will appear as alarm -9 and a Power alarm will appear as alarm
-0. To program a telephone number for Pager dialout, you must
enter Code 1 at the beginning of the telephone number. The
Sensaphone will say "Code one, Pager" when you enter the
command.
Follow the key sequence below to dial a numeric pager:
SET + PHONE NUMBER + any unassigned number key 1-8 +
CODE + 1 + pager telephone number + ENTER
To check your programming:
WHAT IS + PHONE NUMBER + assigned # 1-8
The Sensaphone will say "Pager", followed by the programmed
telephone number.
To send a test page:
SET + TEST + assigned # key 1-8 + ENTER
The Sensaphone will let you listen to the dialout sequence
through its speaker and send you a message that includes the
Sensaphone's telephone number (ID number).
Chapter 4: Communications Programming
52