Quick-Start Programming Steps; Step 1: Set Configuration Of Zones - Phonetics Sensaphone 800 User Manual

Sensaphone Model 800 User's Manual
®
When these steps are completed, the Model 800 is fully
operational and able to monitor temperature, high sound, AC
power failure and battery backup condition; it can also be called
on the telephone for a Status Report or be used for listening to on-
site sounds from any remote location. Now, the unit is ready for
programming.

3.3 Quick-Start Programming Steps

Step 1: Set Configuration of Zones

The Model 800 will scan the 8 external zones and determine
if they are N.O. (normally open), N.C. (normally closed), or
Temperature. If external sensors are added, make sure they are
in their normal positions before proceeding—refer to Chapter 5,
Section 5.1.
1. Press STANDBY to place the Model 800 in Standby
mode.
STANDBY
2. If you have external sensors available, wire the sensors to the
zones on the back of the Model 800 (see Chapter 2,
Section 2.10). Otherwise, skip this step and move to step 3.
3. Press RUN. The System On light glows when the Model 800
returns to Run mode.
STANDBY
4. Press SET.
SET
5. Press CONFIGURE.
CONFIG
6. The Model 800 will audibly recite the new configuration for
each of the eight zones, responding with "normally open",
"normally closed", or "Temperature." If a zone is unused, it
is treated as normally open.
33
RUN
RUN