No Tad In Use; Listen-In Time; Programming The Listen-In Time - Phonetics Sensaphone 800 User Manual

4.7.3 No TAD In Use

If a telephone answering device is not used on the same telephone
line as the Model 800, make sure that the TAD feature is
disabled, or turned off. Only Rings Until Answer programming
will determine how incoming calls are answered. For example,
if you program Rings Until Answer to 3, incoming calls will be
answered in 3 rings.

4.8 Listen-in Time

The Listen-in Time is the amount of time you can listen to sounds
from the Model 800's built-in microphone at its installation
site. When you call in for a Status Report, the Model 800
announces Listen-in Time at the end of its first round of status
readings, saying, "Listen for (programmed time entered)." The
programmable range is from 0 to 255 seconds (or up to 4.17
minutes). The default value is 15 seconds.
The microphone is also used to monitor high sound
level. See Chapter 5, Section 5.10 through Section
5.11.1.

4.8.1 Programming the Listen-in Time

To program the Listen-in Time:
1. Press SET.
SET
2. Press LISTEN TIME. The Model 800 will respond: "Enter
seconds."
9
LISTEN TIME
SOUND
3. Using the number keys, enter the seconds. The Model 800 will
recite the digits as they are pressed.
1
CALL
DELAY
4
MAX CALLS
7
RECOGNITION
TIME
Chapter 4: Communications Programming
NOTE
2 3
VOICE INTERCALL
TIME
REPS
5 6
TEMP LIMITS CALIBRATE
8 9
LISTEN TIME
CLOCK
SOUND
0
ID NUMBER
POWER
56