Radiant Tube Assembly - Re-Verber-Ray LD Series Installation Manual

3.0 Installation
•

Radiant Tube Assembly

Radiant Tube Assembly
To install the radiant tubes:
Place tubes in hangers with the welded seam facing downward and the swaged end of the tube
1
towards the exhaust end of the heater system (see Figure 3.8).
Refer to page 23 for tube installation sequence.
Figure 3.8 • Attach Hangers
Hanger
Slide tube clamps onto radiant tubes (see figure 3.9).
2
Figure 3.9 • Attach Tube Clamps
Concave surface
Radiant Tube
Welded seam
faces down
NOTE: If the tube clamp comes apart, the spacer must be
re-assembled with the spacer's concave surface facing against
the radiant tube surface.
16
LD Series
Swaged End
Tube Clamp