Reflector Assembly - Re-Verber-Ray LD Series Installation Manual

3.0 Installation
•

Reflector Assembly

Reflector Assembly
To install the reflectors (see Figure 3.16):
Attach the reflector center supports onto radiant tubes.
1
Slide each reflector section through the hangers and adjust the reflector tension spring (if applicable)
2
into the V-groove on the top of the reflector. The reflectors should overlap approximately 4 inches.
To prevent the reflectors from shifting, secure the reflector sections together using sheet metal screws,
3
except at the expansion joint (see p.23). NOTE: Installer to supply sheet metal screws.
Attach reflector end caps with polished finish inward to each end of the reflector run. Secure with clips.
4
Reflectors and reflector accessories direct infrared energy to the floor level. The reflector assembly
depends on the heater configuration, proximity to combustibles, and space surrounding the heater.
Before you begin assembly, determine if the use of reflector accessories are necessary (see Chart 3.5).
Figure 3.16 • Reflector Assembly
Radiant
Hanger and
Chain
Reflector Center
Support
Tube
Place at the
mid-point
of the tube
Reflector
4" Overlap
Reflector
End Cap
20
LD Series
Reflector
Tension
Spring
Clips