Safety Signs And Labels - Re-Verber-Ray LD Series Installation Manual

1.0 Introduction • Safety Signs and Labels
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, serious injury or death. Read and understand, the installation,
operating and maintenance instructions thoroughly before installing or servicing this
equipment. Only trained, qualified gas installation and service personnel may install or
service this equipment.

Safety Signs and Labels

Safety warning labels must be maintained on the tube heater and should be replaced if they become
illegible. Contact either your local distributor or the product manufacturer for obtaining replacement signs
or labels.
It is important to provide warnings to alert individuals to potential hazards and safety actions. In locations
used for the storage of combustible materials, ANSI Z83.20b and CSA 2.34 require a placard to be
posted "specifying the maximum permissible stacking height to maintain the required clearances from the
heater to the combustibles" near the heaters thermostat or in absence of such thermostats in a
conspicuous location. Contact Detroit Radiant Products Co. or an authorized dealer for Clearance Safety
Limit Signs or for Clearance Safety Limit Tags (one tag is provided with each heater).
Right Panel
(Valve Compartment)
F/N: LL01 - Clearance Safety Tag
(Affix adjacent to heater's thermostat)
WARNING
!
SERVICE ACCESS PANEL
IGNITER & FLAME SENSE COMPARTMENT
1. Turn off gas & electricity.
2. Remove cover by lifting top
cover upward and outward.
CAUTION: HOT SURFACE.
KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
F/N: LLTB026
SERVICE ACCESS PANEL
IGNITER & FLAME SENSE COMPARTMENT
1. Turn off gas & electricity.
2. Remove cover by lifting top
cover upward and outward.
CAUTION: HOT SURFACE.
KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
16" Burner Tube
INSTALLER
!
AVOID EQUIPMENT FAILURE
THIS 10 FT. TUBE IS THE
COMBUSTION CHAMBER.
The combustion chamber utilizes either 409
stainless, titanium alloy or aluminized steel -
depending on the model number of your heater.
THIS TUBE MUST BE THE FIRST TUBE
FOLLOWING THE BURNER CONTROL BOX.
Rotate the tube's welded seam to bottom.
Consult the manual(s) for further details.
Al-Ti Combustion
Chamber
4
LD Series
F/N: LLTB004
(orange)
Aluminized
Radiant Tube(s)
(if applicable)
F/N: LLTCL002
Lighting Instructions