Specifications; Generator; Engine - Generac Power Systems CorePower Repair Manual

Home standby generator

Table of Contents

Specifications



Caution: Specifications are for reference only, for actual installations always use the most recent version available online.

These specifications are subject to change without notice.

Rated Voltage

Rated Maximum Load Current (Amps) at 240 Volts (LP)*

Main Circuit Breaker

Transfer Switch Load Center Circuits** 30A, 240V

30A, 240V

20A, 120V

15A, 120V

Phase

Number of Rotor Poles

Rated AC Frequency

Battery Requirement

Weight (unit only in lbs.)

Enclosure

Normal Operating Range: This unit is tested in accordance to UL 2200 standards with an operating temperature of -20 °F (-29 °C) to 122 °F. (50 °C). For areas

where temperatures fall below 32 °F (0 °C), a cold weather kit is highly recommended. When operated above 77º F (25º C) there may be a decrease in engine

power. (Please reference the engine specifications section).

These generators are rated in accordance with UL2200, Safety Standard for Stationary Engine Generator Assemblies; and CSA-C22.2 No. 100-04 Standard for

Motors and Generators.

* Natural Gas ratings will depend on specific fuel Btu content. Typical derates are between 10-20% off the LP gas rating.

** Circuits to be moved must be protected by same size breaker. For example, a 15 amp circuit in the main panel must be a 15 amp circuit in the transfer switch.

Type of Engine

Number of Cylinders

Rated Horsepower @ 3,600 rpm*

Displacement

Cylinder Block

Valve Arrangement

Ignition System

Recommended Spark Plug

Spark Plug Gap

Compression Ratio

Starter

Oil Capacity Including Filter

Recommended Oil Filter

Recommended Air Filter

Operating RPM

* Engine power is subject to and limited by such factors as fuel Btu content, ambient temperature and altitude. Engine power decreases about 3.5 percent for each

1,000 feet above sea level; and also will decrease about 1 percent for each 6 C (10 F) above 16 C (60 F) ambient temperature.

Page 4