Installation; Open The Package And Check; Connect The Power Cable - Contec CMS800G User Manual

Revolving the knob key to setup print function. The Corresponding function and the adjustable
ranges are showed in the table3.5:
No
1 SPEED(Print
Speed)
2 LENGTH(Print
Length)
73 BASELINE(Baselin
e offset)
4 BASELINE PRINT Print the ladder-from testing wave.
5 PAPER(Selection of
printing paper type)
6 EXIT

4 Installation

Note: To ensure that the monitor works properly, please read this chapter and Chapter 1 Safety
Guidance. And follow the steps before using the monitor.

4.1 Open the Package and Check

Open the package and take out the monitor and accessories carefully. Put the monitor at safe and
reliable place. Check the components according to the packing list.
Check for any mechanical damage.

Check all the cable, and accessories.

If there is any problem, contact us for your local distributor immediately.

4.2 Connect the Power Cable

Make sure the AC power supply of the monitor complies with the following specification:

100V-240AV, 50/60Hz.
Consider the local power supply range, if the power supply of the monitor exceeds the range,

please add regulator equipment.
Apply the power socket of the monitor. Plug one end of the power cable to the power socket

of the monitor. Connect the other end of the power cable to a grounded 3-phase power output
special for hospital usage.
Connect the ground wire if necessary.

Figure 3.11Print Setup
Table 3.5 The print setup function and adjustable ranges
Function
1cm/min, 2cm/min, and 3cm/min. The default value is 3cm/min.
0④24(hours) ,the interval is 10 minutes.
The default value is 30 minutes.
Adjustable:-10~+10, the interval is 1, the default value is0.
Please select it between American standard printing paper and
Europe standard printing paper.
Return to the upper menu.
Adjustable Range