Connect With Network; Feeding Paper And Removing Paper Jam; Power On The Monitor; Connect Transducers - Contec CMS800G User Manual

4.3

Connect with Network

If the network has been ready, insert the network cable into the RJ45 interface of the monitor.

4.4 Feeding Paper and Removing Paper Jam

If the paper is used up or paper jam happens, you have to feed paper into the recorder, the
operation procedure is as follows:
1 Open the paper cabinet
2
Take out the "Z" type thermal sensitive paper from the wrapper. Put the green safety band to
the left and the face of the paper downward. Please refer to "paper installation note" on the
bottom of the cabinet.
3 Feed the record paper into the slot of the recorder and push out form the middle of the notch.
4
Close the paper cabinet properly.
Removing Paper Jam
When the recorder sounds or the output of the paper improper, open the paper cabinet to check for
a paper jam, then feed the paper again.
Note: Only use the manufacturer approved paper to avoid poor printing quality, deflection,
or paper jam.

4.5 Power on the Monitor

WARNING: If any sign of damage is detected, do not use it on any patient. Contact
biomedical engineer in the hospital or our service engineer immediately.
Turn on the power, and the power indicator lights, the monitoring screen lights.
NOTE: There will be initialization time for some seconds after turn on the monitor to the
monitoring screen shows data, and the system will enter normal monitoring after self-test.

4.6 Connect Transducers

Connect all the necessary transducers, and cables between the monitor and the patient.
Note: please pay attention to the direction when connecting transducer(s), the
connector should head upward.

5. Monitoring

5.1 Operation Procedure

Ultrasound Transducer and TOCO Transducer Positioning showed as Figure 5.1
arrow mark in the