Oki B410 Maintenance Manual page 79

Oki Data CONFIDENTIAL
Category (1st Line)
(16 Characters)
0X ADJST
ENGINE
TEST
ENGINE
RESET
After reset, printer returns to normal operating mode.
"Start Position Setting of Printing" is only for shipment. Do not change the default value.
Note!
43984801TH Rev.1
Item (1st Line) Value
(16 Characters) (2nd Line)
0
1
2
3
4
5
6
7
-8
-7
-6
-5
-4
-3
-2
-1
EP TEST OFF
PAPER
CONNECT
PRT DUTY 1/1
1/10
1/20
1/50
MODE 00
01
02
~
FD
FE
FF
- -
Default Function
[ON DELAY OFFSET]
*
ON DELAY OFFSET TABLE
SELECTION
At setting HEATON Signal Output Time,
set the value that the corresponding
table value has been added to the
resistor.
0: 0.0ms
1: 0.5ms
2: 1.0ms
3: 1.5ms
4: 2.0ms
5: 2.5ms
6: 3.0ms
7: 3.5ms
-8: -4.0ms
-7: -3.5ms
-6: -3.0ms
-5: -2.5ms
-4: -2.0ms
-3: -1.5ms
-2: -1.0ms
-1: -0.5ms
By ENGINE TEST displaying, press
SELECT SW, SUBITEM is displayed on
the 1st Line.
*
In this printer, this setting is not used.
*
Set Duty that is used for Motor
Accelerating Test in the factory. Setting
as 1/n means that after 1 piece of paper
printing, it makes the engine idles away
for n-1 piece of paper amount.
*
The setting is irrevocable because it is
used for engine debug mode.
If set it out of default (00), the printing
stops.
-
Reset the following counters that are
used in engine part.
Drum Total Counter
Drum Counter
•
Printing Total Page Counter
•
But, Printing Total Page Counter is
•
only reset for the count under 500. (This
limit is not compliant in the case of
reset for PJL Command)
4. ADJUSTMENT
Valid Save
- -
- -
- -
- -
- -
- -
79 /