Oki B410 Maintenance Manual page 171

Oki Data CONFIDENTIAL
(10) Setup
Each setting item can be set up by the menu and network administration tool.
Operation Panel Display
Setting item
(Upper level)
TCP/IP
IP version
NETBEUI
NETWARE
ETHERTALK
Frame
IP address setup
IP address
Subnet mask
Gateway address
WEB
TELNET
FTP
SNMP
Network size
Connection to HUB Auto
Factory Default
43984801TH Rev.1
Setting item
Default
(lower level)
*: Default
Enable
*
Disable
IP v4
*
IP v4+v6
IP v6
Enable
*
Disable
Enable *
Disable
Enable
*
Disable
Auto
*
802.2
802.3
ETHERNET II
SNAP
Auto Manual
*
xxx.xxx.xxx.xxx -
xxx.xxx.xxx.xxx -
xxx.xxx.xxx.xxx
*
Enable
*
Disable
Enable
*
Disable
Enable
*
Disable
Enable
*
Disable
Normal
*
Small
*
100BASE-TX
FULL
100BASE-TX
HALF
10BASE-T
FULL
10BASE-T
HALF
Execute -
Specify Enable/ Disable of TCP/IP protocol.
Set an IP version.
Operate with IPv4 at "IPv4". (IPv6 is disabled)
Operate with both IPv4 and IPv6 at "IPv4+v6".
Operate with IPv6 at "IPv6". (IPv4 is disabled)
Specify Enable/ Disable of NETBEUI protocol.
Specify Enable/ Disable of NetWare protocol.
Specify Enable/ Disable of EtherTalk.
Set the frame type.
[Display Conditions]
• "NETWARE" is enabled.
Set the setting method of an IP address.
[Display Conditions]
• "TCP/IP" is enabled, and "IP VERSION" is IP v4 or IPv4+V6.
Set an IP address.
[Display Conditions]
• "TCP/IP" is enabled, and "IP VERSION" is IP v4 or IPv4+V6.
Set the subnet mask.
[Display Conditions]
• "TCP/IP" is enabled, and "IP VERSION" is IP v4 or IPv4+V6.
Set the gateway address.
[Display Conditions]
• "TCP/IP" is enabled, and "IP VERSION" is IP v4 or IPv4+V6.
Specify Enable/ Disable of WEB.
[Display Conditions]
• "TCP/IP" is enabled.
Specify Enable/ Disable of TELNET.
[Display Conditions]
• "TCP/IP" is enabled.
Specify Enable/ Disable of FTP.
[Display Conditions]
• "TCP/IP" is enabled.
Specify Enable/ Disable of SNMP.
[Display Conditions]
• "TCP/IP" or "NETWARE" is enabled.
Normal: usually, this setting is used.
In the NORMAL, even if connected to the HUB having the spanning tree
function, the device operates efficiently. However, when the computer is
connected to two or three small LANs, it takes long to start a computer.
At SMALL, the computer supports two or three small LANs and large
LAN, however, when connected to the HUB having the spanning tree
function, the device may not operate efficiently.
Set a method of link to the HUB.
When setting to Auto, the connection method is automatically selected
for all of the HUB, and connection is tried.
When selecting other items, the connection to the HUB is tried only by
the connection method.
Initialize the network menu.
Appendix D Network Interface
Function
171 / 171