Oki B410 Maintenance Manual page 72

Oki Data CONFIDENTIAL
Category
PERSONALITY PCL
ROLLING ASCII ROLLING ASCII
DOTSHIFT
43984801TH Rev.1
Operation panel display
Setting item Setting item
(Upper case) (Lower case)
ENABLE
DISABLE
IBM PPR III XL ENABLE
DISABLE
EPSON FX ENABLE
DISABLE
ESC/P ENABLE
DISABLE
PS3 EMULATION ENABLE
DISABLE
PCL XL ENABLE
DISABLE
EXECUTE
TRAY1 -4.0MILLIMETER
~
-1.5MILLIMETER
-1.0MILLIMETER
-0.5MILLIMETER
0.0MILLIMETER
+0.5MILLIMETER
~
+3.5MILLIMETER
TRAY2 -4.0MILLIMETER
~
-1.0MILLIMETER
-0.5MILLIMETER
0.0MILLIMETER
+0.5MILLIMETER
~
+3.5MILLIMETER
Default
* Only English is supported for panel
value
*
Change the default of Support PDL Language
for each destination.
*E
The PDL Language that is DISABLE in this
*J MWNU is not displayed on the OP MENU of
*E EMULATE and Administrator MENU of User
Menu. (About "PCL XL", because it does not
*J
have specified menu, no appearance change
*J
is shown even at DISABLE.)
*E
As receiving the printing data of DISABLE
PDL Language, it displays INVALID DATA and
*
discards the received data.
In the case that set the Japan Oriented "IBM
PPR III XL" and "EPSON FX" as ENABLE, the
*
operation is not guaranteed.
"PS3 EMU" is only displayed at PSE
implementation.
It means Read Only While "PCL" can not
be set as DISABLE. (Normally, it is used by
ENABLE. Even set as DISABLE it still process
received data.
Default Value: For Japan Oriented equipment
sets "IBM PPR" and "EPSON FX" as
DISABLE, yet "ESC/P" as ENABLE. For Non
Japan Oriented equipment sets "IBM PPR"
and "EPSON FX" as ENABLE, yet "ESC/P" as
DISABLE.
Set PRINTING Rolling ASCII as continuously
printing.
Set Rolling ASCII Paten as continuously
printing.
Press "ENTEN" switch at this menu displaying.
After EXECUTE displayed in the lower case,
press "ENTER" switch to settle the execution.
Press "ON-LINE" switch to initialize and then
continuously printing is available.
For the termination of this mode, it is to
press "ON-LINE" switch and wait for printing
stopped, and then shut down power or press
"CANCEL" switch.
After this operation it can not return to any
other maintenance mode.
Set landscape dot Shift of Tray 1 while printing.
In this area, even EEPROM RESET such as
ROM Ver.UP is not initialized.
*
Set landscape dot Shift of Tray 1 while printing.
Item is displayed even Tray 2 is not
*
implemented.
In this area, even EEPROM RESET such as
ROM Ver.UP is not initialized.
4. ADJUSTMENT
Function
display
72 /