36
Section C - Electrical Components
3.
If the voltage checks good remove the
inverter from the compressor by removing
one screw at the bottom of the inverter
that goes through the bracket welded
to the compressor. Pull the inverter
away from compressor. Use a small flat-
bladed screwdriver to remove the plug
from the compressor terminals. Using an
ohmmeter, check the resistance between
the compressor terminals (See testing
compressor). If the compressor checks good
replace the Inverter.
Remove screw
COMPRESSOR
The compressor has a 3 phase, 4 pole Brushless
DC motor.
Motor
3 phas e
4 poles
B rus hles s
To test the compressor using your Ohmmeter,
check the resistance between the terminals. Check
should read 10 ohm + or - 10 % useing drawing to
test.
TEST
2 TO 3
2
1
L ubric ation
Modified
S ys tem
for lower
s peeds
P ower input
E lec tronic
C ontrol
replac es S tarting
devic e and OP
3
TEST
3 TO 1