Show Room Setting; Advance Into Defrost Cycle Manually - Electrolux E23CS75DSS0 Service Manual

Section C - Electronic Control System

Show Room Setting

Activation
Press and hold Fresh Food Temperature UP
(WARMER) Key while pressing the fresh food
temperature DOWN (COLDER) key 3 times within
5 seconds. Both displays will flash "0" for 10
seconds. While the displays are flashing, press the
Freezer Temperature UP key to confirm activation
Deactivation
Mode automatically deactivates at a POR.
Active Function
Displays
Freezer/Fresh Food Temperature Keys
Fresh Food Lights
Alarm Key - Key Tone ONLY
Air Filter Key - Key Tone and green LED toggleson
& off. All other functions are disabled including
alarm(s) enabling.
NOTE
The "Show Room" mode, which during
activation doesn't recognize Alarm/Power Off
conditions.
Change Between Fahrenheit and Centigrade
To change form Fahrenheit to Centigrade on
example 1 Press the temp mode key. On example 2
press and hold the temp display key.
Example 1

Advance Into Defrost Cycle Manually.

Activation
Press and hold Freezer Temperature UP
(WARMER) key while pressing the Freezer
temperature DOWN (COLDER) key 5 times within
6 seconds. This will advance the processor into
defrost cycle.
Deactivation
Press and hold Freezer Temperature UP
(WARMER) key while pressing the Freezer
temperature DOWN (COLDER) key 5 times within
6 seconds. This will advance the processor out of
defrost cycle. Or just leave the refrigerator alone
and it will go through a normal defrost cycle and
start running after the defrost limit switch has
turned off the heater and the controller has allowed
for a normal drip time.
Example 2
43