Electrolux E23CS75DSS0 Service Manual page 39

Section C - Electrical Components
3. Remove ice container and rail assembly. The
multiconnector at back of rail assembly must
be disconnected before rail assembly will
come free.
4. Loosen the 2 screws holding ice maker to
right side of compartment just enough to lift
ice maker free. The multiconnector must be
disconnected before ice maker will come free
from compartment.
5. Remove two rail assembly supports. (two
screws on each one).
6. Remove four screws from evaporator cover.
7. Remove five screws on evaporator air duct
cover.
8. Disconnect two leads to defrost heater.
CAUTION
This is a good time to test the heater.
Check resistance of defrost heater using
a multimeter. Resistance should be very
close to 30 ohms. Replace defrost heater if
resistance readings are out of range.
9. Unclip ground wire hooked to drain trough.
10. Remove screw holding evaporator bracket
through drain trough to cabinet.
11. Remove rivet holding bracket to trough and
set bracket aside for reuse.
12. Remove screw holding drain trough to
cabinet .
13. Lift up and pull evaporator and drain trough
out at bottom.
CAUTION
Use caution not to damage suction line or cap
tube.
14. Slide drain trough off evaporator.
15. Remove retainer clamp from bottom of
evaporator that holds heater in place.
16. Grab heater from bottom and pull free of
evaporator. It's very snug so you'll need to
use a little force.
17. Replace with new defrost heater.
18. Re-assemble in reverse order.
Figure C8
Defrost
Heater
Figure C9
39