To Test Solenoid Assembly; To Remove Lamp Socket And Light Bulb; Ice Auger And Crusher Assembly - Electrolux E23CS75DSS0 Service Manual

Section G - Ice and Water Dispenser
to Solenoid Assembly on the back of Motor
Cover. (See Figure G1)
6. Disconnect two (2) leads hooked to solenoid
coil (Leads are blue with a white stripe and
white - See Figure G1).
7. Remove four (4) mounting screws on front
of Motor Cover and pull Solenoid Assembly
free. (See Figure G3)
8. Replace assembly in reverse order.

To Test Solenoid Assembly:

1. Read ohms value of solenoid coil using Multi
meter on resistence scale. (Put test leads on
terminals where blue with white stripe and
white wires were disconnected from Step 6 of
procedure "To Remove Solenoid Assembly").
2. If resistence reading is extremely high or low,
replace solenoid coil.
To Remove Lamp Socket and Light
Bulb:
1. Disconnect refrigerator from electrical supply.
2. Slide Ice Container forward and off of Rail
Assembly. Remove two (2) screws mounting
the rail assembly to the Evaporator Cover.
3. Lift up on Rail Assembly and pull forward,
freeing it from mounting brackets.
4. Disconnect Molex connector located at back
of Rail Assembly and pull Rail Assembly free.
5. Disconnect yellow and white wires connected
to lamp socket located behind Motor Cover.
6. Press in on two tabs on bottom of lamp
socket base and push through mounting hole.
(See Figure G4)
7. Replace lamp socket in reverse order.
Ice Auger & Crusher Assembly
To remove Ice Auger & Crusher Assembly:
Figure G3
1. Remove four (4) screws holding Ice
Container Front to Ice Container.
2. Remove two (2) screws on underside of Ice
Container, holding Crusher Housing to
container.
3. Remove screw holding Control Rod to
container, located on underside of container.
4. Remove three (3) Hex head screws holding
Crusher Housing to Front Plate. (See Figure
G5)
5. Remove E-ring and washer on front of
Crusher Housing. (See Figure G5)
6. Slide Control Rod free of Crusher Housing
Gate.
The Crusher Blades are very sharp. Use
protective gloves when handling Crusher
Blades.
Figure G4
CAUTION
103
Figure G5