Parts Replacement; To Replace; To Replace Ice Stripper; To Replace Fill Trough - Electrolux E23CS75DSS0 Service Manual

EXAMPLE: An ice maker is test-cycled and
the water fill sample is 93 cubic centimeters.
Subtracting 80 cc from 93, the adjustment needed
is 13 cc. Since one turn of the adjusting screw
changes the fill 18 cc, ¾ of a turn clockwise would
reduce the fill about 13 cc, the desired amount.
(This example is for manual models only.)

Parts Replacement

Disconnect electrical supply to refrigerator.
To Replace Front Cover (Figure F4)
1. Remove ice maker from freezer.
2. Ensure that ice maker is at room
temperature before removing Cover.
3. Remove screw at the top of the cover and tip
it out until the tab at the bottom comes out of
the housing.
5. Install in reverse order.
To Replace Ice Stripper (Figure F5)
1. Remove ice maker from freezer.
2. Pull out on the stripper about 1 inch back
from the front the ice maker till the retaining
tab is away from the tab on the ice mold.
3. Pull back on ice stripper to disengage it from
front of mold support housing.
4. Replace in reverse order.
Figure F 5
On Off Switch
Fill Trough
Ice Stripper
Sensing Arm Extension
Section F - Ice Maker
To Replace Fill Trough (Figure F6)
1. Remove ice maker form Freezer.
2. Push trough retaining tab back against the
mold.
3. Pull the trough up until it is clear of the mold.
4. Replace in reverse order.
Figure F 4
To Replace Ejector Blades (Figure F5)
1. Remove ice maker form freezer.
2. Remove front cover.
3. Remove two screws holding mounting plate
in place.
4. Carefully remove mounting plate,
disengaging end of ice maker control arm
and ejector blades from motor coupling,
noting relative position of ice maker control
arm spring.
5. Remove fill trough and bearing.
6. Turn blades to 12 O'clock position.
7. Slide ejector blades back and up to remove.
8. Replace in reverse order.
9. Lubricate bearing ends of ejector with
Ice Mold
Ice Ejector
Sensing Arm
87