Electrolux E23CS75DSS0 Service Manual page 71

Section E - Refrigeration System
8. Using a 1/2" drill bit, open hole drilled in Step
7 to 1/2" from back of product. See Figure 2.
9. Remove stubs of old heat exchanger from
evaporator and install new heat exchanger
into evaporator.
10. Push heat exchanger through hole in cabinet
(See figures 3 & 5.) and set evaporator back
in place.
11. Slide Armor-Flex over heat exchanger until
cover is against hole at back of cabinet. The
excess cap tube can be wound around the
suction line.
12. Seal the hole on the inside and outside using
Permagum. (See Figues 3 & 5)
13. The one piece cover can now be installed
over heat exchanger. Place open end of
cover with top of compressor compartment
opening. Attach cover to back of cabinet
using screws provided. There is no need to
predrill holes as the screws are self cutting.
(See Figure 4.)
14. Seal hole and end of old heat exchanger with
Permagum. (See Figure 6.)
15. Replacr Drier-Filter.
16. Evacuate and recharge system.
17. Bend remaining tubing to fit into machine
compartment opening, being careful not to
set up any excess noise from line vibration.
(See Figure 7.)
18. Run product to make sure refrigerant is
circulating.
19. Reinstall evaporator and machine
compartment cover.
Old heat
exchanger location
Drill 1/2 inch hole
through cabinet
1 inch below old
heat exchanger.
Figure 2
Push the heat
exchanger through the
hole in the cabinet.
Install the armorflex
over the heat exchanger.
Seal hole using the
permagum.
Figure 3
Using screws in kit, attach
cover to back of cabinet.
Line lower cover up
with top of machine
compartment opening.
Figure 4
Using the permagum
provided in kit, seal
hole and end of old
heat exchanger.
Figure 5
Using the permagum
provided in kit, seal
hole and end of old
heat exchanger.
Figure 6
Bend tubing
as shown to fit
inside machine
compartment
Figure 7
71