Table of Contents
Advertisement
user Programmable Features (cont'd)
Feature #11 - Confirmation Chirps
Siren + horn
Siren Only
On Demand (siren+horn) (press "brake" 3 times to program)
Off
This feature selects whether the siren and/or horn give confirmation chirps Both
outputs will always sound when the alarm system is triggered or in panic mode
nOTE: Both the siren and horn outputs must be connected for this feature to function.
Feature #12 - Anti-Carjacking
ignition Only
(press "brake" 1 time to program)
Door Only
(press "brake" 2 times to program)
ignition + Door (press "brake" 3 times to program)
Off
(press "brake" 4 times to program) - DEFAuLT
This selects between the 2 forms of anti-carjacking protection Details on using anti-
carjacking protection are described on page 7
installer Programmable Features
This group of Installer Programmable Features are all accessed as a group in the second level of
features' programming These features have a direct affect upon the system's operations related
to the installation and vehicle type AnD ShOuLD OnLy BE ChAnGED By ThE inSTALLER!!!
Feature #1 - Remote Start Activation From The whiTE/BLuE wire
1 pulse
(press "brake" 1 time to program) - DEFAuLT
2 pulses
(press "brake" 2 times to program)
3 pulses
(press "brake" 3 times to program)
4 pulses
(press "brake" 4 times to programm)
This feature changes how the remote start feature is activated from the (-) activation input wire
Feature #2 - PinK/whiTE (iGn #2)wire Function
ignition
(press "brake" 1 time to program) - DEFAuLT
Accessory
(press "brake" 2 times to program)
Starter
(press "brake" 3 times to program)
This feature changes the operation of the unit's large PINK/WHITE output wire This feature
should only be programmed by the installer
Feature #3 - Engine Detection method
Tachless hi
(press "brake" 1 time to program) - DEFAuLT
Tachless Lo
(press "brake" 2 times to program)
Tach wire
(press "brake" 3 times to program)
Data Tach
(press "brake" 4 times to program)
Crank Only
(press "brake" 5 times to program)
This feature selects the method in which the remote start monitors the engine's running condition
in remote start mode
"Tachless hi" sensitivity mode uses a preset crank time (see installer feature #7) and monitors
the vehicle's voltage level to determine if the engine is running This setting looks for a voltage
increase of 03v after cranking
"Tachless Lo" sensitivity mode operates like the "Tachless Hi" setting but looks for a voltage
increase of 05v after cranking
"Tach wire" Before this setting is programmed, refer to the "Violet/White wire" section of the
installation manual for proper wiring connection and the Tach Learn Procedure It will crank the
engine for up to 3 seconds or until a tach signal is detected
10
(press "brake" 1 time to program)
(press "brake" 2 times to program) - DEFAuLT
(press "brake" 4 times to program)
Advertisement
Table of Contents
