Digital Clock Setting Procedure - Hitachi EX 3600-6 Operator's Manual

Station Presetting Procedure
1. Select the desired station using tuning switches (5).
(Refer to the "Tuning Procedure" section.)
2. Press and hold one station preset (4) for more than 1
second until an electronic tone is heard. Now, the
selected station is preset for the selected station
preset. The frequency of the preset station will be in-
dicated on digital display (7).
Once the presetting is complete for a station preset (4),
the radio will be tuned to the preset station when station
preset (4) is pressed (for less than 1 second).

DIGITAL CLOCK SETTING PROCEDURE

NOTE: In order to set the clock, digital display (7) must
be in the time display mode.
1. Press display mode button (6) to indicate the hour
display on digital display (7).
2. Press and hold time set button (RST) (8) for longer
than 1 second. The hour display will start flashing and
the time set mode will be selected.
3. Press time set button (H or M) (8) to set the clock.
Each time set button (H or M) (8) is pressed, the time
display will increase by one. If time set button (H or
M) (8) is pressed and held, the time display will
change continuously.
•
When setting the hour, press time set button (H)
(8).
•
When setting the minute, press time set button (M)
(8).
The time is displayed in 12 hour standard.
If either of the switches (H) or (M) is pressed and held,
the hour or minute display will change continuously
until the switch is released.
4. When the hour display is "12," if time set button (H)
(8) is pressed, the hour display will be reset to "1."
When the minute display is "59," if time set button
(M)(8) is pressed, the minute display will be reset to
"00." However, the hour display remains unchanged
in this case.
5. After the clock setting is complete, press and hold
time set button (RST)(8) again for longer than 1 sec-
ond, or turn the radio switch OFF to end the clock
time setting procedure. Digital display (7) stops
flashing and changes to stay ON.
OPERATOR'S STATION
1-28
4
5
6
8
7
M1G6-01-026
7
M1G6-01-026