Engine - Hitachi EX 3600-6 Operator's Manual

B. ENGINE
Parts
1. Engine Oil Check
Oil Level
2. Check LED Monitor Signal (on Reserve Tank)
3. Engine Oil
Change
Change
4. Replace Engine Oil Filter
NOTE: First time only
When change engine oil, change the oil in engine oil pan and reserve tank at the same time.
Total quantity of oil (Engine Oil Pan and Reserve Tank) achieves 500 hours replacement interval.
It differs according to the kind of engine oil used.
The capacity of reserve tank is 280L (74 US gal).
NOTE: The machine has a reserve system.
Reserve system is the system that oil is circulated between engine oil pan and reserve tank by the
pump on reserve tank.
Classification API Service
of Oil Class
CF-4
Standard
CG-4
CH-4
Premium
CI-4
NOTE: • Oils with nominal ash content must be 1.0 to 1.5 percent mass. Oils with higher ash content, up to
1.85 percent ash, can be used in areas where the sulfur content of the fuel is normally 1 to 1.5
percent mass. Limiting ash content is critical to the prevention of valve and piston deposit formation.
• The machine is shipped from the factory is filled with lubricants, Hitachi Super Wide DH-1 15W-40
(Class CF-4 (API Service Classification)).
• Refer to the manual for Cummins Engine.
• For further details, refer to Cummins B/No. 3810470-01 "Maintenance and Operation Practices for
Maximum Engine Life".
MAINTENANCE
Classification
of Oil
Engine Oil Pan
Reserve Tank
Engine Oil Pan
Premium
Reserve Tank
Engine Oil Pan
Standard
Reserve Tank
Engine Oil Viscosity Requirements
Type
All Season Multigrade
All Season Multigrade
All Season Multigrade
All Season Multigrade
Quantity
10 50
1
1
1
260L
(68.7 US gal)
120L
(31.7 US gal)
260L
(68.7 US gal)
258L
(68.2 US gal)
4
Viscosity Grade (SAE)
15W-40
15W-40
15W-40
15W-40
7-36
Interval (hours)
250 500 1000 1500
Temperature Ranges
-18° to 50°C (0° to 122°F)
-18° to 50°C (0° to 122°F)
-18° to 50°C (0° to 122°F)
-18° to 50°C (0° to 122°F)
2000