Hitachi EX 3600-6 Operator's Manual page 263

1. Adjusting Greasing Interval
Turn adjusting switch (9) located in room (8) under
the cab to the desired position out of four possible
positions: 3, 5, 10, and 15 minutes.
Greasing Interval
(minutes)
2. Adjusting Greasing Volume
Loosen locknut (11) on injector (2). Turn adjusting nut
(10) clockwise until it stops. This is the minimum de-
livery position of 0.168 cm
nut (10) counterclockwise approximately 10 turns.
This is the maximum delivery position of 1.165 cm
3
(0.071 in ). Select appropriate greasing volume be-
tween the maximum and minimum volumes. Tighten
locknut (11).
NOTE: Injectors (2) have been adjusted as shown be-
low at the time of shipment:
Front attachment joint pins: Maximum
Swing bearing: Minimum
Center joint: Minimum
Model
Min. Volume 0.168±40%
Max. Volume 1.165±40%
MAINTENANCE
3
5
10
15
3 3
(0.010 in ). Turn adjusting
SL-I SL-II
1.165±15%
8.163±5%
8
9
3
7-124
M18M-07-053
M18M-07-057
10
11
2
M117-07-173