Pre-Ride Checks Chart - APRILIA SXV / RXV 450 550 Use And Maintenance Book

SXV / RXV 450 - 550
2.6.2.

PRE-RIDE CHECKS CHART

DANGER
Before departure, always carry out a preliminary check of the vehicle to ensure that it functions correctly
and safely. See the PRE-RIDE CHECKS CHART.
Failure to comply with these checking procedures can cause severe personal injuries or damage to the
vehicle.
Do not hesitate to consult your aprilia Authorized Dealer if there is something you do not understand
about the operation of the controls, or in case you suspect or discover failures.
It does not take long to perform the checks and this step will guarantee you greater safety.
Component
Front and rear disk brakes
Throttle
Engine oil
Wheel/tires
Brake levers
Clutch
Steering
Side stand
Fastening elements
Drive chain
Fuel tank
Coolant
Engine stop switch (
)
Lights, warning lights, horn,
rear brake light switches and
electrical devices
Check the operation, the idle stroke of the control levers, the fluid level and make sure
there are no leaks.
Check the pads for wear.
If necessary, top up the fluid tank.
Make sure that it works smoothly and that it is possible to open and close it completely,
in all steering positions. Adjust and/or lubricate, if necessary.
Check and/or top up if necessary.
Check the tire surface, the inflation pressure, wear and tear and any damage.
Remove any foreign matter that may be stuck in the tread grooves.
Make sure that they work smoothly.
Lubricate the articulations and adjust the stroke if necessary.
Check for proper operation, check clutch lever free play, clutch fluid level and check for
leaks. If necessary, top up the fluid; the clutch must work without snatching and/or
slipping.
Make sure that the steering rotates smoothly, without any clearance or looseness.
Make sure that it operates correctly. Make sure that when the stand is let up or down
there is no friction and that the spring tension brings it back to its normal position.
If necessary, lubricate joints and articulations.
Make sure that the fastening elements are not loose. If necessary, adjust or tighten
them.
Check the slack.
Check the fuel level and top up, if necessary.
Check the circuit for leaks.
Make sure that the fuel cap is correctly closed.
Radiator level should cover radiator plates.
-
Make sure that it operates correctly.
Check horn and indicators for proper operation. Change bulbs or fix a failure, if
necessary.
Check
USE
2 - 31