Edid Minder; Factory Edid; Output Edid; User Slots - Extron electronics HDMI DA Series User Manual

EDID Minder

EDID Minder ensures that the connected source sees the EDID of a display, even if a display
is not connected. Depending on the EDID assignment (by SIS command), the EDID of a
connected display can be stored automatically, or the user can manually select from the table
of factory EDID files. This EDID is stored on an EEPROM located at the HDMI input.
The
720p 60 Hz, 2ch Audio (slot 34 in the EDID Lookup Table). The unit reverts to this configuration
after a factory reset.

Factory EDID

The user can select from 48 factory loaded EDID files, each catagorized by rate type (PC or
HDTV), video format (DVI or HDMI), audio type (2-Ch or Multi-Ch), and native resolution.

Output EDID

EDID from each connected output is automatically saved in the corresponding output
slots. This EDID is retained until a different display is connected to the output or the unit is
power-cycled. If no display is connected to the specified output when the unit is powered on,
then the factory default EDID (720p @ 60 Hz, 2-Ch audio) is used.

User Slots

Four user-loaded slots are available to save the EDID of any connected display. EDIDs saved
to these slots are retained after a power cycle. Upon a factory reset, these EDIDs revert to the
factory default (720p @ 60 Hz, 2-Ch audio).
EDID Lookup Table is shown on the following page. The default EDID assignment is
HDMI DA Series • Operation 13