Rc Radio Receiver Card (Optional); Pwr Power Supply Card; Ip Card (Optional); Monitoring Software Compatibility - ENIGMA II Programming Manual

2.3 RC radio receiver card (optional)

The optional RC radio receiver card works as a special line card in the system – it
provides event receiving through UHF radio (440..450MHz). RC card can handle two
independent radio channels, which are displayed as line card "A" and "B" in the system.
Event management and CPM monitoring way is similar to LC line cards. In standalone
mode the RC card can store up to 500 events, which will be sent automatically to CPM
when the connection is restored.

2.4 PWR power supply card

PWR power supply card ensures voltage for all cards in the system. The input of PWR
requires 16.5 VAC / 18 VDC, which is generated by an external transformer unit / power
supply unit. PWR has got battery charging circuit, batteries can be connected to
external connectors. In case of main power trouble battery powered operation is
switched automatically. The capacity of batteries should be between 7 Ah and 15 Ah.
The PWR continuously check the state of main power and batteries, and it reports the
status to CPM unit.

2.5 IP card (optional)

Receiver has 8 slots to connect IP Ethernet based receiver cards. IP cards can work in
standalone mode, they control individually the incoming events through Ethernet line.
Then they forward the events to central processing unit of main receiver through internal
receiver bus. By means of IP cards gives extended range in IP receiving functions
(comparing to CPM card in base receiver unit). Additionally it provides possibility to
connect the system to a secondary Internet provider.

2.6 Monitoring software compatibility

The device can work with the most generally used monitoring software packages.
During development the receiver has been tested with the following monitoring software
packages:
ALARM SYS (recommended)
•
SIMS
•
MYMAS
•
5