Display - Card Programming And Status Checking - ENIGMA II Programming Manual

3.4 DISPLAY – card programming and status checking
After pushing the DISPLAY button (DISPLAY LED lights continuously) you can enter
into the following window:
CARDS
1 OK
2 OK
3 -----
4 -----
5 -----
6 -----
7 -----
8 -----
1 : OK
MON OFF
F1
CARDS – Telephone line cards / IP cards status
READY – Telephone line card / IP card is OK.
RING – Ring on telephone line card.
INCOMING CALL – Telephone line card received the incoming call (incoming event
codes can be seen).
TEL LINE ERROR – Card is OK, but line has trouble.
ID: xxx – Call is from xxx phone number.
RADIO – Radio receiver card status
OK – Radio receiver card OK (signal level scale below).
Event codes can be seen during radio receiving, received signal strength in brackets (7
– minimum, F – excellent).
F1 (MON ON / OFF) – Speaker On / Off.
F3 (STATUS) – Card status (and firmware version checking, RESET button for card
restart.
F4 (HANG UP) – To abort stucked phone call.
RADIO
_ A OK
I████████
B -----
I
USB A
LPT
AC
SETUP
F2
14
OK COM-B
–– IPLINK
OK BATTERY
STATUS
F3
16:48:17
R
OK
OK
HANG UP
F4